Wiring Diagram 1(2.6 KB)   Wiring Diagram 2(1.8 KB)
Standard Configuration is 8 Individual Lead Wires
Minimum 12 inches in Length
Motor modelWire sizeWire diameter (Inches)
Cable information: Motor are supplied with 12 inch lead wires extended out of the NPT threaded hole on the motor. Typical set up is to use pluming fittings as shown below to allow maintenance and access.
Empire Magnetics Part number 00-0510-0021 four conductors of 22 AWG, with overall shield and jacket, nominal cable OD .165 inches, minimum bend radius 0.825 inches. Tinned copper ,S-R PVC insulated, conductors cabled. Foil aluminum-polyester shield. Standed tinned copper wire. Chrome PVC jacket. 100% shield coverage.